Ok, time to test what you just soldered. First use the continuity
check on a multimeter to make sure the wires aren't shorting to
ground or to each other. Make sure your switch is in the off
position. Power up your iPhone. Hopefully it didn't smoke :)
Now go into minicom to tty.baseband and send a few
commands, AT a few times will do. It should respond OK. Now
flip your switch, the baseband should stop responding. Even
when you flip it back, the baseband still shouldn't respond. Be
sure your switch is off, then open another ssh and run
"bbupdater -v" You can get bbupdater off the ramdisk. This
should reset the baseband, and minicom should start working
again. If it did this, your soldering is most likely good, and you
are ready to actually start unlocking your phone!!!
skip to main |
skip to sidebar
No comments:
Post a Comment